All

Knuckle & Motor Holder Set for Mini Z AWD

Replacement for KYOMZ403

Pinion Gear Set, 7 Tooth (3pcs), Mini-Z

These left & right axle carriers require larger 6x13 mm ball bearings (sold separately. Includes bearing adapters for 6x12 mm ball bearings (2)...

Toe links, Revo® (TUBES red-anodized, 7075-T6 aluminum, stronger than titanium) (128mm, fits front or rear) (2)/ rod ends, rear (4)/ rod ends, fron...

Servo horns, steering and throttle (for non-Traxxa®s servos (Hitec, JR, KO, Airtronics))

Pull ring (2), fuel tank cap (1)/ engine shut-off clamp (1)

Output shaft, transmission

Spool, differential (eliminates differential. Use off-road only) (requires #5379X ring gear)

Gear set, 2-speed close ratio (2nd speed gear 40T, 13T-16T input gears, hardware)

Gear set, 2-speed wide ratio (2nd speed gear 38T, 13T-18T input gears, hardware)

Gear, 1st speed, 43T

Primary clutch assembly/ 2x9.8mm pin/ 6x8x0.5 TW (1)

Reverse installation kit (includes all components to add mechanical reverse (no Optidrive®) to Revo®) (includes 2060 sub-micro servo)

Wing mount, center / wing washers (for Revo®)

Spring, shock (red) (GTR) (4.1 rate tan) (1 pair)

Spring, shock (red) (GTR) (4.9 rate silver) (std. front 120mm) (1 pair)

Servo mounts, steering (left & right)

Differential output yokes (2)/yoke pins M3/12.5 (2)

Big Bore shocks (hard-anodized & PTFE-coated T6 aluminum) (assembled with TiN shafts and springs) (front & rear) (4)

Ball bearing, blue rubber sealed (15x24x5mm) (2)

Suspension arms (upper) (2) (fits T-Maxx®/E-Maxx)