TRAXXAS

Differential output yokes (2)/yoke pins M3/12.5 (2)

Bulkheads, front (upper & lower)

Turnbuckles, toe-links, 61mm (front or rear) (2) (assembled with rod ends and hollow balls)

Steering bellcranks/ servo saver/ servo saver spring/ steering support/ 4x7x2.5 PB (4)/ 5x0.8mm NL (1)

Bellcrank posts (steering)(2)

Servo horn, steering/ linkage, steering (3x30 threaded rod)/ rod ends (2)/ hollow balls (2)

Pull ring (1)/ fuel tank cap (1)/ engine shut-off clamp (1)/ 3x10 BCS (1)

Driveshaft assembly (1), left or right (fully assembled, ready to install)/ M3/12.5mm yoke pin (1)

Driveshafts, Jato (steel constant-velocity) (assembled with inner and outer dust boots) (1 pair)

Carriers, stub axle, (rear) 6061-T6 aluminum (titanium-anodized)

Mounts, suspension pin (rear anti-squat blocks) (1.5, 2.25, 3.0 & 3.75 degree) (1 each)

Engine mount/ engine mount spacers (2)/ 3x15 CS with washers (4)/ 4x18 BCS (2)/ flat-head engine mount screws 3x10 (2)

Brake disc (semi-metallic material)

Cover, differential

Gaskets, differential/transmission

Gear set, two-speed (2nd speed gear, 29T/ input gear, 17T steel)

Gearbox halves (right & left)

Turnbuckle, aluminum (red-anodized), front toe link, 61mm (1) (assembled with rod ends and hollow balls) (see part 5539X for complete set of Jato a...

Sway bars (front) (includes soft, medium, hard)

Seal kit, receiver box (includes o-ring, seals, and siliconee grease)

Hold down bracket, electronic speed control (Castle Creations Mamba Monster brushless system)

Door, battery compartment (2) (fits right or left side)

Skidplate, transmission, nylon (black)/ cover

Gear, 20-T pinion (0.8 metric pitch, compatible with 32-pitch) (fits 5mm shaft)/ set screw