traxxas

Clutch bell (15-tooth)/5x8x0.5mm fiber washer (2)/ 5mm e-clip (requires 5x11x4mm ball bearings part #4611) (1.0 metric pitch)

Ball bearings, 7x17x5mm (1)/ 12x21x5mm (1) (TRX® 3.3, 2.5R, 2.5 engine bearings)

Rod, connecting (TRX® 2.5, 2.5R, 3.3)

Head protector, cooling head (2) (TRX® 2.5, 2.5R)

Gaskets, cooling head: 0.15, 0.25, 0.35mm (1 each) (TRX® 2.5, 2.5R)

Wrist pin/ wrist pin clips (2) (TRX® 2.5, 2.5R)

Carburetor body/ fuel inlet plug/ 5x.9mm O-ring (1-each) (TRX® 2.5, 2.5R, 3.3)

Wrist pin clips (3) (TRX® 2.5, 2.5R, 3.3)

End cap, carburetor body/ 6.2x1.2mm O-ring/ (1-each) (TRX® 2.5, 2.5R, 3.3)

Screw, idle speed/ 2x1mm O-ring (1-each) (TRX® 2.5, 2.5R, 3.3)

Dust boot, throttle (2)/ return spring (TRX® 2.5, 2.5R, 3.3)

Flywheel nut (TRX® 2.5, 2.5R, 3.3)

Pipe coupler, molded (blue)/ exhaust deflecter (rubber, blue)/ cable ties, long (2)/ cable ties, short (2)

Pipe coupler, molded (black)/ exhaust deflecter (rubber, black)/ cable ties, long (2)/ cable ties, short (2)

Pipe coupler, molded (for use with pipes 5152 (T-Maxx®) & 4452R) (TRX® 2.5, 2.5R, 3.3)

Needle assembly, high-speed (with fuel fitting)/ 2.5x1.15mm O-ring (2)/ 5.3x7.8x.6mm crush washer (2) (TRX® 2.5, 2.5R, 3.3)

Needle, low-speed/ 2x1mm O-ring (2) (TRX® 2.5, 2.5R, 3.3)

O-ring, header 12.2x1mm (TRX® 2.5, 2.5R, 3.3)

Air filter inserts, foam (3) (pre-oiled) (TRX® 2.5, 2.5R, 3.3)

Air filter body (high volume)/ filter support/ cap/ foam filter, pre-filter/ air filter base/ wire mount/ hardware (1 each)

Backplate/ 20x1.4mm O-ring (for engines with starter) (TRX® 2.5, 2.5R, 3.3)

Header, blue-anodized aluminum (for rear exhaust engines only) (TRX® 2.5, 2.5R, 3.3)

Wrist pin (1), Wrist Pin Clips(2) (TRX® 3.3)