TRAXXAS

Differential CV output drive (machined steel) (1)/ screw pin (with threadlock) (1)/ cross pin (1)/ drive pin (1)/ set screw (1)

Stub axle, CV style (machined steel) (1)/ cross pin (1)/ drive pin (1)

Half shaft set, short (plastic parts only) (internal splined half shaft/ external splined half shaft/ rubber boot) (assembled with glued boot) (2 a...

Half shaft set, long (plastic parts only) (internal splined half shaft/ external splined half shaft/ rubber boot) (assembled with glued boot) (2 as...

Motor mount, finned aluminum

Motor mount hinge post/ 4x12mm BCS (1)/ 4x10mm CS with split and flat washer (1)

Servo horn (with built-in spring and hardware) (for Summit locking differential)

Tires & wheels, assembled, glued (Geode chrome wheels, paddle tires, foam inserts) (2) (use with 17mm splined wheel hubs & nuts, part # 535...

Cover, gear/ 3x8mm CS (1)

Gear, locking differential output/ differential slider/ 3x12mm screwpin

Housing, differential (front & rear)

Plate, motor

Plate, motor (for single motor installation, use with gear cover #5677R)

Drive strut

Propeller shaft/ flex cable, DCB M41 (380.9mm)

Stuffing tube (assembled with liner)

Mount, stuffing tube (upper & lower)/ 4x10mm BCS (stainless) (2)/ 3x10mm CS (stainless) (2)

Rudder (127.5 mm)/ rudder arm/ hinge pin/ 3x15mm BCS (stainless) (2)/ NL 3.0 (2)/ 4x3mm BCS (stainless, with threadlock) (1)

Rudder mount/ rudder pivot/ 4x14mm BCS (stainless) (4)/ NL 4.0 (2)

Rudder pushrod, assembled/ servo horn/ 3x18mm BCS (stainless) (1)/ 3x15mm CS (stainless) (1)/ 3x6mm CS (stainless) (1)/ NL 3.0 (1)

Motor mount/ flex cable guard, DCB M41

Alignment tool, drive strut, DCB M41

Hold down, battery/ hold down retainer/ battery post/ foam spacer/ angled body clip